How to Correct a Drive Slice

Typical slicer’s grip.

Did you know that the slice shot with a driver is a common shot among amateur golfers? A slice is any shot that curves hard to the right in the air (for a right-handed player). Unfortunately, after hitting these types of shots, golfers often find themselves in the woods. A slice shot is caused by a poor grip and setup, an outside-to-in downswing path, and an open clubface. An outside-to-in path occurs when the golfer reaches too far on the downside, bringing the club down to the right of the ball (outside), relative to the target line. This forces them to pull the clubhead closer (inside) to strike the ball on the tee. An open clubface means the clubface points to the right of the target at impact. To eliminate a slice, you need the proper grip and setup, an inside-to-out downswing path and a square clubface. After making these corrections, you can enjoy a slice-free golf game in 4 easy steps.

Step 1
Grip the club with the left hand first (again, for a right-handed golfer). Position the grip mainly in the fingers of your left hand. With the club grounded, you should be able to see at least two knuckles of your left hand as you look down at the club. Golfers with a big slice should strive to see three knuckles of the left hand. The “V” formed by your left index finger and thumb should point toward your right shoulder. Set your right-hand grip to compliment the left. The “V” formed by your right index finger and thumb should also point to your right shoulder.

Step 2
Position the ball off the inside of your front foot, about even with your heel, to promote an upward strike of the golf ball. Striking the ball on the upswing will help promote a straighter flight and greater distance. Most slices with the driver result from a downward angle of attack, which produces weak distance and a slicing spin. Set up to the ball with your head a few inches behind the ball to help promote an upward strike. With your head behind the ball and your right hand grip below the left, you’ll have a natural tilt in your shoulders at address. The proper shoulder tilt at address will promote a good shoulder turn on the backswing.

Step 3
Swing the club back until you see your left shoulder under your chin. Your shoulder turn and backswing are complete once you get the left shoulder under your chin. With the proper shoulder turn, you can swing the club down on an inside-to-out path.

Step 4
Swing the club down on an inside-to-out path. Square the clubface by rotating the toe (outside edge) of the club over the heel (inside edge) as you swing through impact. This eliminates an open clubface at impact, which contributes to a slice. Rotating the toe of the club over the heel will straighten out your ball flight or produce a slight right to left flight.

Tip: Keep your grip pressure light to help the toe of the club rotate over the heel.

Leave a Reply

2 thoughts on “How to Correct a Drive Slice”

  1. I am having trouble with a slice. I will use these four simple steps to correct it. Thank you for this informative tutorial. If you have any questions, please get in contact with me.

  2. Sometimes I find it is as easy as just moving the ball back towards the center of your stance at address. I think its easy for the ball to creep forward towards the front foot over time as feels more aggressive but I find when I do this I end up leaving the club face open as i’m in effect having the leave the club head slightly behind where it should be in order to strike the ball… my body is starting to turn through but the club head hasn’t yet struck the ball, so moving the ball back towards the centre of my stance just improves the timing on having everything lined up together at impact.